If you want to streamline downloading the exports from the THREE, you can enable automatic downloading and allow for insecure downloading specifically to the local domain name. In the URL bar, cli...
Posts made by Joseph Chiu
-
Bypassing the insecure download check in Chomeposted in General 3D Scanning Discussion
-
Idea - Calibration for coordinate orientationposted in Feature Requests
For a calibrated scan, it would be nice if there could be a mat (real or virtual) placed on the turn table that allows for the X Y and Z axis to be oriented to be aligned to the principal axes.&nbs...
-
Electric screwdriver assembly threadposted in General 3D Scanning Discussion
Love this! Absolutely gorgeous result! The attention to details is amazing. Did you separate the crimped terminals from the wire in your modeling? Or is that done by "painting" t...
-
Quick-and-dirty project: wiper blade retaining clipposted in General 3D Scanning Discussion
Did a relative quick-and-dirty scan -- I didn't want to spend too much time getting all of the nooks and crannies -- enough for me to get a good feel for the part to model against. It's nice to be...
-
Floating points isolation & hole filling settingsposted in Feature Requests
From a UI standpoint, what could be helpful here is a sectioned view so that you can hide or mask an area behind (or in front of) a certain cutting plane. If that can be made to be dyn...
-
Focus point, focus distance, depth of focus, and scanning qualityposted in General 3D Scanning Discussion
Is there a rough rule of thumb we should be following in terms of achieving the best positional accuracy? I'm guessing that you get the best result when the project and camera focus are at th...
-
Bose Mini Remote - Success after firmware updateposted in General 3D Scanning Discussion
Ok, this is pretty awesome. I was able to make a magnetic nest for the remote so that I can mount the remote on a pole. Video in imgur album
-
Feature request: export to Google Drive/Dropboxposted in Feature Requests
Yes. If I am doing a capture session away from my desktop (similar to the early example of scanning the air intake manifold while in the garage) and can successfully create the merged mesh th...
-
Feature request: export to Google Drive/Dropboxposted in Feature Requests
This is way lower on the priority, but when using a tablet/chromebook to do a capture session, it would be nice to be able to shut down and pack everything away after the capture is done. But...
-
Bose Mini Remote - Success after firmware updateposted in General 3D Scanning Discussion
I had noise reduction set to 20. The capture settings were always the same as shown here, while brightness and turntable scan/sweep were occasionally adjusted as needed.
-
Bose Mini Remote - Success after firmware updateposted in General 3D Scanning Discussion
I also posted a video showing off the different merged meshes and textures here (Twitter)
-
Bose Mini Remote - Success after firmware updateposted in General 3D Scanning Discussion
I'm still learning how to use the scanner and also tools to work with the resulting data (Meshmixer and TurboCAD), but I just had a really successful result tonight and had to share. The resu...
-
Electric screwdriver assembly threadposted in General 3D Scanning Discussion
@Jordan Cain I have the same challenges when working with largely flat items!
-
Automatic dual-brightness/exposureposted in Feature Requests
An item I am currently experimenting on has a "two tone" design where the upper half of the device is ivory colored and the bottom half is charcoal colored. To top it off, the plastic is some...
Search
Latest topics
Latest posts
Forum statistics
- Page views (24h):
- 53
- Page views (30d):
- 1,363
- Topics:
- 48
- Posts:
- 177
- Members:
- 49
Newest members
Most liked authors
-
Jordan Cain
27 -
Drew Shark
14 -
Joseph Chiu
11
